Loading branch status…
Home / Pipes & Fittings / Sali QB60 0.5HP Peripheral Water Pump – Booster Pump for Home & Garden in Nairobi
Sali QB60 0.5HP Peripheral Water Pump – Booster Pump for Home & Garden in Nairobi
Sali · Model QB60 0.5HP

Sali QB60 0.5HP Peripheral Water Pump – Booster Pump for Home & Garden in Nairobi

KSH 5,500
In stock
About this product
Sali QB60 0.5HP Water Pump | Booster Pump Nairobi | Shabbiri Hardware
SALI

Sali QB60 0.5HP Peripheral Water Pump – Booster Pump for Home & Garden in Nairobi

A compact, heavy-duty electric water pump for boosting household water pressure, filling overhead tanks, garden irrigation and washing – built with a brass impeller and a pure copper-wound motor.

Model QB60
Single Phase Motor Brass Impeller 100% Copper Wire Continuous Duty Clean Water

Product Overview

The Sali QB60 water pump is one of the most popular 0.5HP booster pumps in Kenya for homes, apartments, small farms and car wash points. It is a peripheral (vortex) clean water pump that delivers strong pressure from a small, quiet unit.

Whether your shower runs weak, your upper floor gets little water, or you need to push water from a ground tank to a roof tank, the Sali QB60 gives you steady, reliable pressure. Its single-phase motor runs on normal household power, so no special wiring is needed. The cast pump body, brass impeller and copper-wound motor are built for long hours of continuous work.

Technical Specifications

BrandSali
ModelQB60
Pump TypePeripheral (vortex) clean water pump, surface mounted
Motor Power0.5 HP (0.37 kW)
Power SupplySingle phase, 220–240V, 50Hz
Rated CurrentAbout 2.5A
Motor SpeedAbout 2850 rpm
Maximum FlowAbout 35 litres per minute
Maximum HeadAbout 33–35 metres
Maximum Suction Lift8 metres
Inlet × Outlet1 inch × 1 inch (25 mm) threaded
ImpellerBrass
Motor Winding100% copper wire
Mechanical SealCeramic–graphite
Insulation ClassClass B
ProtectionIP44
DutyHeavy-duty, continuous work
LiquidClean water, free of sand and abrasive particles
Max Water TemperatureUp to 60°C
Max Ambient TemperatureUp to 40°C

Figures are typical for the QB60 model. Always confirm with the rating plate on the pump.

Key Features & Benefits

Strong Pressure Boost

The peripheral impeller design gives high pressure from a small motor – ideal for showers, taps and upper floors.

Brass Impeller

Resists rust and wear far better than plastic impellers, for a longer service life.

100% Copper Motor

Pure copper winding runs cooler, uses power efficiently and handles long working hours.

Good Casting

Solid pump body and motor housing built to handle daily use in Kenyan homes and farms.

Household Power

Plugs into normal single-phase supply – no three-phase connection needed.

Compact & Easy to Fit

Small footprint with standard 1 inch connections, easy to mount next to any tank.

Where to Use It

  • Boosting water pressure in homes and apartments
  • Pumping water from a ground tank to a roof tank
  • Garden watering and small sprinkler systems
  • Kitchen gardens and small-scale drip irrigation
  • Car wash and compound cleaning
  • Supplying solar water heaters and geysers
  • Shallow wells and water transfer between tanks
  • Pairing with a pressure tank or automatic controller

How to Install & Use

Choose a Dry, Shaded SpotMount the pump on a firm, level base close to the water source, protected from rain and direct sun, with space around it for air to cool the motor.
Connect the Suction PipeUse a 1 inch pipe to the inlet. Fit a foot valve with a strainer at the bottom if drawing from below the pump. Keep the suction line short, airtight and rising gently towards the pump.
Connect the Delivery PipeAttach a 1 inch pipe to the outlet and fit a gate valve so you can control flow and service the pump easily.
Seal All JointsUse thread tape or sealant on every connection. Any air leak on the suction side will stop the pump from drawing water.
Prime the PumpRemove the priming plug and fill the pump body and suction pipe completely with clean water, then close the plug firmly.
Connect the PowerUse a properly earthed socket with the correct voltage. A qualified electrician should install a suitable circuit breaker.
Start and CheckSwitch on and watch for steady water flow within a minute. If no water comes, switch off, re-prime and check the suction line for leaks.
Automate if NeededFor constant pressure at the taps, pair the pump with a pressure tank or an automatic pressure controller.

Care & Safety Tips

✓Always Do

  • Prime the pump with clean water before the first start
  • Clean the foot valve strainer regularly
  • Switch off power before any maintenance
  • Check pipe joints for air or water leaks
  • Drain the pump if it will stand unused for a long time

✕Never Do

  • Run the pump dry – it damages the seal and impeller
  • Pump sandy, muddy or dirty water
  • Pump fuel, chemicals or any liquid other than clean water
  • Leave the motor exposed to rain or flooding
  • Run with the outlet valve fully closed for long periods

Why Buy from Shabbiri Hardware?

Serving builders, plumbers, farmers and homeowners since 1990, Shabbiri Hardware stocks a full range of plumbing and irrigation materials alongside the Sali QB60 – pipes, fittings, foot valves, gate valves, water tanks and more – so you can collect everything for your pump installation in one trip. We are a supply-only store and can share contacts of trusted independent plumbers for installation.

Frequently Asked Questions

Can the Sali QB60 boost water pressure in my house?

Yes. It is a booster pump designed to raise pressure for showers, taps and upper floors when fed from a tank or mains supply.

Can I run the pump without water?

No. The pump body must be filled with water before starting. Running dry damages the mechanical seal and impeller.

Can it pump borehole or dam water with sand?

No. It is a clean water pump. Sand and debris wear out the impeller quickly. For deep boreholes, a submersible pump is the right choice.

Does it need a special electrical connection?

No. It runs on normal single-phase household power. Make sure the socket is earthed and protected by a suitable breaker.

Can I use it with a pressure tank?

Yes. Pairing it with a pressure tank or automatic controller lets the pump start and stop on its own as taps open and close.

Visit Our Branches

Ongata Rongai Branch

Magadi Road, opposite Hashi Petrol Station, Ongata Rongai

Tuala Branch

Magadi Road, past Nazarene University, Tuala

Get in Touch

Call, WhatsApp or email us to check availability of the Sali QB60 0.5HP water pump.

Sali water pump Kenya0.5HP booster pump NairobiQB60 peripheral pump Water pump Ongata RongaiWater pump Magadi RoadGarden irrigation pump
KSH 5,500
In stock
Delivery on request — same-day within Nairobi, next-day countrywide.
Free pickupat Rongai & Tuala branches.
Qty
1
📲 Order on WhatsApp
100% genuine, sourced materials
Secure M-Pesa & card payment
Countrywide delivery arranged
100% Genuine
No fakes, ever
Quality assured
Trusted brands only
Countrywide delivery
Arranged on request
Expert advice
Sales team on WhatsApp

Specifications

BrandSali
ModelQB60 0.5HP
CategoryPipes & Fittings
AvailabilityIn stock
Sourced byShabbiri Hardware Kenya Limited

Customer reviews

No reviews yet — be the first to review this product.

Frequently bought together

Customers who bought this often add these to their order.