
SIKALITE POWDER WATERPROOFING CEMENT
Sikalite® Powder Waterproofing Admixture for Mortar & Concrete
A ready-to-use waterproofing powder you mix into cement and sand. It blocks the tiny pores in plaster, screeds and mortar so water and damp cannot soak through your walls and floors.
Technical specifications
| Brand | Sika |
| Product type | Powdered integral waterproofing admixture |
| Suitable for | Cement/sand mortar, plaster, renders, screeds and concrete |
| Appearance | Beige to off-white powder |
| Packaging | 1 kg bag |
| Recommended dosage | 1 kg per 50 kg Portland cement (2% by weight of cement) |
| When to add | To the dry cement and sand mix, before water |
| Shelf life | 12 months in the original unopened pack |
| Storage | Dry, shaded place; keep away from direct sun and moisture |
| Chloride content | Chloride free |
What Sikalite does
Ordinary sand and cement mortar is full of fine capillary channels. Rain, ground moisture and water from bathrooms travel through these channels and cause damp patches, peeling paint, salt marks (efflorescence) and mould. Sikalite reacts with the cement as it sets and seals those channels, giving you a watertight plaster or screed that still lets the wall breathe out water vapour.
You add it to the dry mix on site. No special tools, no extra coat and no change to the way your fundi works, which makes it one of the most economical ways to waterproof a building in Kenya.
Key benefits
- Stops rising and penetrating dampKeeps external walls, floors and wet areas dry.
- Easy to usePour into the dry mix. One 1 kg bag matches one 50 kg bag of cement.
- Breathable finishWatertight against liquid water, yet lets vapour escape.
- Protects paint and tilesLess flaking, blistering and salt marks on finished surfaces.
- Chloride freeSafe around steel reinforcement.
- Low cost per square metreCheaper than applying a separate waterproof coating.
Where to use it
External plaster & renders
Rain-facing walls, parapets and facades.
Floor screeds & toppings
Ground floors, verandas, balconies and roof slabs before tiling.
Bathrooms & kitchens
Shower areas, wet walls and floors under tiles.
Water tanks & sumps
Internal render of masonry tanks, septic tanks and manholes.
Foundations & plinths
Plinth walls and below-ground plaster against ground moisture.
Jointing mortar
Block and stone walling where joints must not draw water.
How much Sikalite do I need?
The manufacturer's recommended dose is 1 kg of Sikalite for every 50 kg bag of cement, which is 2% by weight of cement.
| Cement used | Sikalite needed | Typical sand (1:4 mortar) |
|---|---|---|
| 1 bag (50 kg) | 1 bag (1 kg) | 200 kg |
| 5 bags (250 kg) | 5 bags (5 kg) | 1,000 kg (1 tonne) |
| 10 bags (500 kg) | 10 bags (10 kg) | 2,000 kg (2 tonnes) |
| 20 bags (1,000 kg) | 20 bags (20 kg) | 4,000 kg (4 tonnes) |
Tip: buy one Sikalite bag for every bag of cement in the waterproof layers of your job. Use clean, well-graded sand; dirty or clayey sand weakens any waterproof mortar.
How to use
- Prepare the surface. Clean off dust, oil and loose material, then wet the wall or slab so it does not suck water from the fresh mortar.
- Dry mix. Mix the cement and sand together until even in colour.
- Add Sikalite. Sprinkle in the full bag (1 kg per 50 kg cement) and keep mixing dry until the powder is evenly spread.
- Add water slowly. Add clean water a little at a time until you get a workable mix. Do not over-water.
- Apply. Plaster or screed as normal. For external walls and tanks, apply in two coats with no gaps or thin spots.
- Cure well. Keep the work damp for at least 3 days with a water spray or wet hessian. Good curing prevents shrinkage cracks.
Safety & good practice
- Wear gloves and a dust maskCement mixes are alkaline and can irritate skin and eyes.
- Do not skip curingWaterproof mortar that dries too fast will crack and leak.
- Seal joints and cornersTreat wall-floor junctions and pipe entries with extra care.
- Store sealedClose opened bags tightly; damp powder loses strength.
Frequently asked questions
Can I use Sikalite for a water tank?
Yes. It is used for the internal render of masonry water tanks, sumps and septic tanks. Apply in two coats and cure well before filling.
Does Sikalite replace a damp-proof membrane (DPM)?
No. Use a DPM under ground-floor slabs and Sikalite in the screed and plaster above. Together they give the best protection.
Will it change the colour of my plaster?
No. The finished plaster looks the same and can be painted or tiled as normal once fully cured.
Can I add more than one bag per bag of cement for extra protection?
Stick to the recommended dose. More powder does not make the mortar more waterproof; good mixing, two coats and proper curing do.
Do you install or apply it?
We supply materials only. We can share contacts of independent fundis and waterproofing contractors on request.
Visit our branches on Magadi Road
Tuala Branch
Order or ask for a quotation
Same-day delivery within Nairobi and next-day delivery countrywide on request. Free pickup at both branches.
Specifications
| Brand | Sika |
| Category | Waterproofing & Sealants |
| Availability | In stock |
| Sourced by | Shabbiri Hardware Kenya Limited |
Customer reviews
No reviews yet — be the first to review this product.
Frequently bought together
Customers who bought this often add these to their order.



