Loading branch status…
Home / Waterproofing & Sealants / HYDRO BAN CEMENTITIOUS WATERPROOFING MEMBRANE
HYDRO BAN CEMENTITIOUS WATERPROOFING MEMBRANE

HYDRO BAN CEMENTITIOUS WATERPROOFING MEMBRANE

KSH 5,200/ bag
In stock
About this product
Waterproofing & Sealants

LATICRETE 302 Waterproof Slurry — Cementitious Waterproofing for Bathrooms, Tanks & Roofs

A polymer-fortified, cement-based waterproofing coating you simply mix with water and brush on. It seals concrete and masonry against water pressure, bonds strongly even under chlorinated and lime water, and gives a tough surface that takes light foot traffic. Available at Shabbiri Hardware, Rongai and Tuala.

Quick Facts

Pack25 kg bag
ColoursGrey & White
CoverageAbout 10 m² per bag (2 mm film, two coats)
Pot life2 hours after mixing
TypeSingle component — just add water
StandardEN 14891, Class CM O P

Technical Performance

Water impermeabilityNo penetration
Initial adhesion strength1.8 N/mm²
Adhesion after heat ageing1.7 N/mm²
Adhesion after lime water contact1.4 N/mm²
Adhesion after chlorinated water contact0.9 N/mm²
Adhesion after freeze–thaw cycles2.2 N/mm²
Crack bridging ability1 – 2 mm
Drying time24 hours
Shelf life1 year, sealed, stored dry and off the ground

Where to Use It

Bathrooms, Toilets & Kitchens

Walls and floors in wet areas, applied before tiling.

Water Tanks

Concrete and masonry water tanks. Drinking-water tanks need approval under local regulations.

Roof Tops

The white grade works as an energy-saving, heat-reflective roof coating.

Balconies & Terraces

Seals open slabs exposed to rain and standing water.

Fountains & Water Features

Ponds, fountains and decorative water features.

Basements & Structural Concrete

Cellar walls, plus protection of concrete against carbon dioxide, chlorides, sulphates and humidity.

Features & Benefits

  • Strong adhesion, even under chlorinated and lime water
  • Smooth, creamy slurry that is easy to brush or roll
  • Ready to use — no liquid additive needed
  • Seals against water under high (positive) hydrostatic pressure
  • Good abrasion and scratch resistance; takes light foot traffic
  • Bridges fine hairline cracks in the substrate
  • Can be applied to a damp surface
  • Tiles, plaster or paint can go over it once cured

Every adhesion result above passes the EN 14891 minimum of 0.5 N/mm². Figures are typical laboratory values from the manufacturer; site results depend on preparation and workmanship.

How to Apply

1

Prepare the surface

Work between 4 °C and 35 °C. The surface must be sound and free of dirt, oil, loose paint, laitance and curing compounds. Level rough concrete with a sand–cement screed (wood-float finish or better), keeping it within 6 mm over 3 m. Dampen dry or dusty surfaces and sweep off standing water. Do not cover expansion joints.

2

Mix

Pour about 7.3 – 7.5 litres of clean water into a clean bucket, add the full bag of powder and mix with a slow-speed drill mixer for 5 minutes until smooth. Let it stand for 5 – 10 minutes, then remix for 1 minute.

3

Apply two coats

Brush, roll or trowel the first coat. While it is still wet, embed glass-fibre mesh at corners, joints, wall–floor junctions and around pipes. Apply the second coat once the first is completely dry, keeping the total film at least 1.5 mm thick.

4

Cure and test

Protect the work while it cures. Allow 7 days for full strength (at 25 °C), then flood-test before tiling or filling tanks.

Limitations & Safety

  • Not for negative-side water pressure (water pushing from behind the coating).
  • Contains Portland cement and silica sand — wear gloves, goggles and a dust mask; rinse skin or eyes with plenty of water on contact.
  • Do not swallow. Keep out of reach of children.
  • The substrate must be rigid and stable enough to carry tile or stone finishes.

Why Buy from Shabbiri Hardware

  • Genuine LATICRETE stock from an established hardware supplier serving builders since 1990.
  • Two branches on Magadi Road — Ongata Rongai and Tuala — with free pickup.
  • Delivery on request within Nairobi and countrywide.
  • One-stop waterproofing — fibre mesh, brushes, rollers, tile adhesives and grout in the same order.
  • Supply only — ask us and we will share contacts of independent installers.

Frequently Asked Questions

Do I need to add a liquid or second component?

No. It is a single-component powder — mix it with clean water only.

Can I tile over it?

Yes. It is designed for wet-area walls and floors under tiles. Let it cure fully and flood-test first.

Can it be left exposed on a roof?

Yes. The white grade acts as a heat-reflective roof coating and handles light foot traffic.

How many bags do I need?

Divide your area in square metres by the per-bag coverage shown in Quick Facts and round up. Add a little extra for rough surfaces and wastage.

Will it stop damp coming through a basement wall from outside?

Not when applied on the inside face — it is not rated for negative-side pressure. Apply it on the side facing the water.

Visit or Contact Us

Ongata Rongai Branch

Magadi Road, opposite Hashi Petrol Station

Get directions to Rongai

Tuala Branch

Magadi Road, past Nazarene University

Get directions to Tuala
KSH 5,200/ bag
In stock
Delivery on request — same-day within Nairobi, next-day countrywide.
Free pickupat Rongai & Tuala branches.
Qty
1
📲 Order on WhatsApp
100% genuine, sourced materials
Secure M-Pesa & card payment
Countrywide delivery arranged
100% Genuine
No fakes, ever
Quality assured
Trusted brands only
Countrywide delivery
Arranged on request
Expert advice
Sales team on WhatsApp

Specifications

Model302
CategoryWaterproofing & Sealants
AvailabilityIn stock
Sourced byShabbiri Hardware Kenya Limited

Customer reviews

No reviews yet — be the first to review this product.

Frequently bought together

Customers who bought this often add these to their order.